RECOM announces the launch of the RPL-3.0, an ultra-compact, low-cost, LGA point-of-load converter with wide-range input and adjustable output.
3D Power Packaging® concept
RECOM has taken its ‘3D Power Packaging®’ concept to a higher level with the launch of the RPL-3.0, a tiny, high-efficiency point of load converter rated at 3 amps, with wide input range from 4V to 18V and adjustable output from 0.8V to 5.2V.
The 10-pad thermally-enhanced LGA device incorporates an integrated inductor and substrate-embedded control IC, all in a 3 x 3mm footprint with a profile of 1.45mm.
RPL-3.0 features
Just input/output capacitors and voltage setting resistors are required for a complete PoL solution
The RPL-3.0 features full functionality with tight voltage regulation, comprehensive protection, output voltage sensing, on/off control, and a power good signal.
Just input/output capacitors and voltage setting resistors are required for a complete PoL solution for operation up to 120°C with suitable derating.
Applications
The RPL-3.0 is ideally suited for distributed power architectures, portable equipment, imaging systems, and general telecom/industrial applications where high current and high power density are important.
An evaluation board RPL-3.0-EVM-1 is available to demonstrate the device performance in customers’ applications.
High performance
Matthew Dauterive, RECOM DC/DC Product Manager, comments, “With its three-amp rating, wide input and output range, and tiny footprint, our new RPL-3.0 point of load converter achieves performance that can’t be matched by a discrete solution in the same space."
He adds, "The product supports our motto of ‘RECOM for’ – highest power density.”